ER Doc Watch

Built in the USA with the best parts sourced from around the world!

Movement: Miyota 6S21.

• Japanese movement built by Citizen watch company.
• 2 positioned chronograph.
• 2 recessed sub-dials. 60 min. and 60 second.
• Pull/Push crown used to set the time and date and to adjust chronograph settings.
• 1/5” Chronograph Hand

Case: 46mm wide, 11.5mm thick 316 stainless steel.

• At 11.5mm, this watch has a sleek profile on your wrist, unlike many of the 46mm+ sized watches that look big and bulky.
• The case uses 4 screws to fasten it to the back, allowing us to center the case-back engraving.
• 316 stainless steel is the “go-to” steel for all high-end watches. It is a surgical grade stainless steel with a polished finish.

Hands: Luminescent markers on the minute and hour hands, as well as on the 2 sub-dials.

Strap: Genuine oil tanned leather, Nylon NATO, or tactical rubber made in the USA.

• 22mm wide.
• Stainless steel hardware.

Sapphire Crystal Window: Used in most high-end watches, it provides a much higher scratch resistance than the more common mineral glass.

• Hardness of 9 on the Mohs scale.
• Only surpassed by diamond in terms of hardness.
• Sourced from Switzerland

Water Resistance: By no means is this a diving watch, but it is water resistant to 100 meters (Note. Not water proof). Not recommended to spend a prolonged amount of time in the water due to the leather strap.

Other internal components: Top and bottom rockers are 100% stainless steel, and they run through a stainless steel routing into the movement.

• A lot of cheaper watches will use a plastic router that breaks easily.
• The stainless steel adds an additional cost but increases the strength by an order of magnitude.